1)Start with a piece of HIGHLAND HEATHER card stock cut at 8in by 7-1/2in. On the LONG side, score at 3/4in, 3-3/4in, 4-1/2in,7-1/2in. On the SHORT side, score at 3/4in, 4-3/4in, 5-1/2in. Crease on all the score lines using your BONE FOLDER. Using your PAPER SNIPS cut away excess card stock. Your treat box should look like the template below when you're finished.
2) Before putting the box together, round the corners of the front flap with the DETAILED TRIO PUNCH. Then adhere the three DSP panels using TOMBOW, two cut at 3-7/8in by 2-7/8in and one cut at 1-7/8in by 2-7/8in. Punch a hole in the bottom of the front flap using the DETAILED TRIO PUNCH again to allow for ribbon the be threaded through the completed box. Finally used the LABEL ME LOVELY PUNCH to create a fancy edge to the treat pocket.
3)Apply a
piece of TEAR & TAPE on the 1/2in edge strip and assemble the box. Close
the flap on the box and run some REAL RED FAUX LINEN RIBBON through the hole
and tie just above the hole.
4)Stamp and emboss the UR
CUTE heart on HIGHLAND HEATHER card stock. Cut out the heart and an additional BLUSHING
BRIDE card stock using the coordinating die.
Adhere to each other as shown and then place on the box using DIMENSIONALS.
No comments:
Post a Comment